ESP8266Download firmware + circuit designNota1: Se não funcionar desligar a alimentação do ESP8266 e voltar a ligar Nota2: Se não funcionar retirar o chip do arduino + repetir Nota1 Nota3: Verificar se a porta com está correta Nota4: é normal aparecer a mensagem "Leaving... Failed to leave Flash mode" -- Depois de atualizar Retirar o GPIO0 de Gnd > desligar alimentação do ESP8266 e voltar a ligar (neste processo o chip do ESP8266 fica novamente protegido de flash) https://www.youtube.com/watch?v=_NgTWZN-DzA Note1: If it does not work, turn off the power to the ESP8266 and switch it on again Note2: If it does not work remove the arduino chip + repeat Note1 Note3: Verify that the com port is correct Note4: It is normal to see the message "Leaving ... Failed to leave Flash mode" -- After updating Remove the GPIO0 from Gnd> turn off power to the ESP8266 and reconnect (in this process the chip of the ESP8266 is protected again from flash) |
||
Página em construção